Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- With the aid of an assistant, install the front floor console assembly (1) into the vehicle.
- Connect the electrical connectors.
- Connect the electrical connectors.
- Install Front Floor Console Trim Plate (1)
- Install Front Floor Console Trim Plate (1)
- Carefully guide the front floor console pins into the instrument panel assembly.
- Install and tighten Front Floor Console Retainer Bolts (2) (Qty: 5) to 9 N.m (80 lb in)
- Install Front Floor Console Bolt Access Hole Cover (1)
- Install the transmission range selector lever cable to the transmission control lever base. Insure the cable retainer (1) is fully secured to the transmission control lever base.
- Connect the transmission range selector lever cable terminal (2) to the shift lever pin.
- Install and tighten Front Floor Console Retainer Bolts (2) (Qty: 5) to 9 N.m (80 lb in)
- Install Front Floor Console Bolt Access Hole Cover (1)
- Install and tighten Front Floor Console Trim Plate Bolts (2) (Qty: 2) to 1 N.m (9 lb in)
- Install Front Floor Console Cup Holder Liner (1)
- Install Transmission Control Lever Knob (3). Refer to Transmission Control Lever Knob Replacement
- Install Front Floor Console Extension Panel - Right (3). Refer to Front Floor Console Extension Panel Replacement - Right Side
- Install Front Floor Console Extension Panel - Left (3). Refer to Front Floor Console Extension Panel Replacement - Left Side
CAUTION:
Refer to Fastener Caution .
WARNING:
After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.