LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 389 (Engine Controls And Fuel - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Fuel Injection Fuel Rail Assembly Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Injection Fuel Rail Assembly And Fasteners (With Tightening Sequence)
    GM4310701Courtesy of GENERAL MOTORS COMPANY
  1. Install Fuel Injection Fuel Rail Assembly (2) into the cylinder head evenly.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Hand tighten the two outer fuel rail fasteners to seat the injectors.
  3. Start and hand tighten the remaining fuel rail fastener.
  4. Tighten the fuel rail fasteners (1) in the sequence shown above:
    1. Install and tighten Fuel Injection Fuel Rail Fasteners (1) (Qty: 3) to 25 N.m (18 lb ft)
  5. Install the NEW fuel feed intermediate pipe. Refer to Fuel Feed Intermediate Pipe Replacement 
    6. Fig 2: Fuel Injection Fuel Rail Wiring Harness And Electrical Connector
    GM4310634Courtesy of GENERAL MOTORS COMPANY
  6. Connect Electrical Connector (1)
  7. Inspect for fuel leaks using the following procedure:
    1. Turn ON the ignition, with the engine OFF for 2 seconds.
    2. Turn OFF the ignition, for 10 seconds.
    3. Turn ON the ignition, with the engine OFF.
    4. Inspect for fuel leaks.
  8. Install Fuel Injection Fuel Rail Noise Shield. Refer to Fuel Injection Fuel Rail Noise Shield Replacement 
scientia non olet · About LEMON Manuals