Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Position Sensor - Bank 1 (Right Side) Exhaust

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove Valve Rocker Arm Oil Control Valve - Bank 1. Refer to Valve Rocker Arm Oil Control Valve Replacement (Bank 1)
1	Camshaft Position Sensor Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Sensor WARNING: Refer to Safety Glasses Warning . Procedure Use compressed air to remove debris from the Camshaft Position Sensor and surrounding cavities prior to removing the camshaft position sensor. Disconnect the electrical connector.
3	Camshaft Position Sensor Seal Ring NOTE: Always install the camshaft position sensor O-ring supplied with the NEW camshaft position sensor. If reinstalling the sensor, inspect the camshaft position sensor O-ring and replace as necessary. Lubricate the camshaft position sensor O-ring with clean engine oil prior to installing the camshaft position sensor.