LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 389 (Engine Controls And Fuel - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove Intake Manifold. Refer to Intake Manifold Replacement
    2. Fig 1: Camshaft Position Actuator Solenoid Valve Electrical Connector And Bolt
    GM4316491Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect Electrical Connector (1)
  3. Remove Camshaft Position Actuator Solenoid Valve Bolt (2)
    4. Fig 2: Camshaft Position Actuator Solenoid Valve, O-Ring And Seal
    GM4316621Courtesy of GENERAL MOTORS COMPANY
  4. Remove Camshaft Position Actuator Solenoid Valve (1)
  5. Inspect the camshaft position actuator solenoid valve O-ring (2) and replace as necessary.
    6. NOTE:
    • ALWAYS install the camshaft position actuator solenoid valve seal supplied with the NEW valve.
    • If reinstalling the camshaft position actuator solenoid valve, inspect the valve seal and replace as necessary.
  6. Remove and DISCARD Camshaft Position Actuator Solenoid Valve Seal (3)
scientia non olet · About LEMON Manuals