LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 383 (Engine Controls And Fuel - 2.5L (LCV) - Repair Instructions) >> Repair Instructions >> Engine Oil Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  2. Remove the right front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation
    3. Fig 1: Oil Pressure Sensor Electrical Connector
    GM4375295Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect Electrical Connector (1)
    4. Fig 2: Battery Negative Cable And Ground Stud
    GM4375606Courtesy of GENERAL MOTORS COMPANY
  4. Remove Battery Negative Cable Ground Stud (1)
  5. Reposition Battery Cable (2)
    6. Fig 3: Engine Oil Pressure Sensor
    GM4375489Courtesy of GENERAL MOTORS COMPANY
  6. Remove Engine Oil Pressure Sensor (1)
scientia non olet · About LEMON Manuals