LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 383 (Engine Controls And Fuel - 2.5L (LCV) - Repair Instructions) >> Repair Instructions >> Engine Oil Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Oil Pressure Sensor
    GM4375489Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Component Fastener Tightening Caution .

  1. Install and tighten Engine Oil Pressure Sensor (1) to 35 N.m (26 lb ft)
    2. Fig 2: Battery Negative Cable And Ground Stud
    GM4375606Courtesy of GENERAL MOTORS COMPANY
  2. Reposition Battery Cable (2)
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install and tighten Battery Negative Cable Ground Stud (1) to 40 N.m (30 lb ft)
    4. Fig 3: Oil Pressure Sensor Electrical Connector
    GM4375295Courtesy of GENERAL MOTORS COMPANY
  4. Connect Electrical Connector (1)
  5. Install the right front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals