Camshaft Position Sensor Replacement - Intake

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Position Sensor - Intake

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement Remove Battery Tray. Refer to Battery Tray Replacement
1	Camshaft Position Sensor Fastener CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Sensor Procedure Disconnect the electrical wiring harness connector from the camshaft position sensor. Install a NEW seal if not replacing the sensor.

Callout

Component Name

Preliminary Procedures

Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
Remove Battery Tray. Refer to Battery Tray Replacement

Camshaft Position Sensor Fastener

CAUTION:

Refer to Fastener Caution .

Tighten
10 N.m (89 lb in)

Camshaft Position Sensor

Procedure

Disconnect the electrical wiring harness connector from the camshaft position sensor.
Install a NEW seal if not replacing the sensor.