Camshaft Position Actuator Intake Solenoid Valve Replacement

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Position Actuator Intake Solenoid Valve

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove Air Cleaner Outlet Front Duct. Refer to Air Cleaner Outlet Front Duct Replacement Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
1	Camshaft Position Actuator Solenoid Valve Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Actuator Solenoid Valve - Intake Procedure Disconnect the electrical wiring harness connector from the camshaft position actuator intake solenoid valve. Install a NEW seal if not replacing the solenoid valve.

Callout

Component Name

Preliminary Procedures

Remove Air Cleaner Outlet Front Duct. Refer to Air Cleaner Outlet Front Duct Replacement
Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement

Camshaft Position Actuator Solenoid Valve Bolt

CAUTION:

Refer to Fastener Caution .

Tighten
10 N.m (89 lb in)

Camshaft Position Actuator Solenoid Valve - Intake

Procedure

Disconnect the electrical wiring harness connector from the camshaft position actuator intake solenoid valve.
Install a NEW seal if not replacing the solenoid valve.