LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Power Transfer Unit - GKN 761) >> Repair Instructions - On Vehicle >> Transfer Case Bracket Replacement (With LGX Engine) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transfer Case Bracket-To-Transfer Case Bolts And Bracket
    GM4288910Courtesy of GENERAL MOTORS COMPANY
  1. Position the bracket (3) to the transfer case.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transfer case bracket to transfer case bolts (2) and tighten to 58 N.m (43 lb ft).
  3. Install the transfer case bracket to engine bolts (1) and tighten to 58 N.m (43 lb ft).
  4. Install the right wheel drive shaft. Refer to Front Wheel Drive Half Shaft Replacement - Right Side (AWD)
scientia non olet · About LEMON Manuals