Intermediate Drive Shaft Replacement
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove Power Transfer Unit Case. Refer to Power Transfer Unit Case Replacement
NOTE:
Check power transfer case fluid level. Refer to Approximate Fluid Capacities , and Adhesives, Fluids, Lubricants, and Sealers . |
|
| 1 | Power Transfer Unit Intermediate Drive Shaft Clip
NOTE:
Remove and DISCARD the retainer. |
| 2 | Power Transfer Unit Half Shaft Seal - O-Ring
NOTE:
Remove and DISCARD the O-ring seal. |
| 3 | Power Transfer Unit Intermediate Drive Shaft Seal
CAUTION:
When replacing power transfer unit case seals, use appropriate GM tools along with a hydraulic press. Failure to do so may result in misalignment or damage to the seal and/or power transfer unit.
NOTE:
Remove seal with a thin flat putty knife or equivalent. Inserting the blade of the tool between the outside diameter of the seal and the extension housing surface.
CAUTION:
Do not nick, scratch or damage the sealing surface. The sealing surface is a machined surface. Damage to the machined surface can cause leakage. Special Tools
Equivalent regional tools: Refer to Special Tools . |
| 4 | Power Transfer Unit Intermediate Drive Shaft Bearing Retainer |
| 5 | Power Transfer Unit Intermediate Drive Shaft Bearing Retaining Ring (Qty: 2) |
| 6 | Power Transfer Unit Intermediate Drive Shaft Bearing Procedure
|
| 7 | Power Transfer Unit Intermediate Drive Shaft |