Removal Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle
- Loosen the transmission front mount bolt (1). Refer to Transmission Front Mount Replacement
- Loosen the transmission rear mount bolt (1). Refer to Transmission Rear Mount Replacement (Front Wheel Drive)Transmission Rear Mount Replacement (All Wheel Drive)
- Position two floor jacks with wood blocks under the engine and transaxle in order to support the powertrain assembly.
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle
- Loosen ONLY the engine mount to engine mount bracket bolts (1). Refer to Engine Mount Replacement
- Loosen ONLY bolts (3) at the left transmission mount (5). Refer to Transmission Mount Replacement - Left Side
NOTE:
Only the transmission mount to transmission bolts should be loosened. Bolts (1 and 4) should remain tightened during the balancing procedure.