Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Reposition both floor jacks and blocks of wood in order to allow a 1/8 inch gap between the mount and bracket.
- Shake the powertrain vigorously by hand from front to rear and allow the powertrain to settle.
- Tighten the engine mount to engine mount bracket bolts (1). Refer to Engine Mount Replacement
- Tighten bolts (3) at the left transmission mount (5) in sequence shown. Refer to Transmission Mount Replacement - Left Side
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle
- Tighten the transmission front mount bolt (1). Refer to Transmission Front Mount Replacement
- Tighten the transmission rear mount bolt (1). Refer to Transmission Rear Mount Replacement (All Wheel Drive)Transmission Rear Mount Replacement (Front Wheel Drive)
- Remove the jack stands and wood blocks supporting the engine and transaxle from underneath the powertrain.
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle
CAUTION:
Refer to Fastener Caution .
Fig 2: Left Transmission Mount And Transmission Mount To Transmission Bolts (With Tightening Sequence)
NOTE:
Bolts (1 and 4) should remain tightened during the balancing procedure.