Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Install the crankshaft balancer with NEW fastener. Use EN-51577-1 Crankshaft Balancer Remover (1) and breaker bar (2) prevent the crankshaft from rotating while tightening the NEW crankshaft balancer fastener (3).
- Tighten the crankshaft balancer bolt to 150 N.m (111 lb ft) plus an additional 140 degrees using the EN-45059 meter.
- Install the drive belt. Refer to Drive Belt Replacement
CAUTION:
Refer to Fastener Caution .