LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 360 (Engine Mechanical - 2.5L (LCV)) >> Repair Instructions - On Vehicle >> Balancer Shaft with Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the oil pump. Refer to Balancer Shaft with Oil Pump Assemble 
    2. Fig 1: Balancer Shaft with Oil Pump And Bolts
    GM4176256Courtesy of GENERAL MOTORS COMPANY
  2. Install Balancer Shaft with Oil Pump (2)
  3. Loosely install Balancer Shaft with Oil Pump Bolts (1) (Qty: 8)
    4. Fig 2: Balancer Shaft With Oil Pump Bolt Tightening Sequence
    GM4176261Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  4. Tighten Balancer Shaft with Oil Pump Bolts in sequence (Qty: 8)

    Tighten

    1. First pass  58 N.m (43 lb ft)
    2. Final pass  58 N.m (43 lb ft)
  5. Install Timing Chain Crankshaft Sprocket. Refer to Timing Chain Crankshaft Sprocket Replacement 
  6. Install Oil Pan. Refer to Oil Pan Replacement (2WD) Oil Pan Replacement (AWD) 
scientia non olet · About LEMON Manuals