Assembling Components

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

When assembling components, use only the sealant specified or equivalent in the service procedure.
Sealing surfaces should be clean and free of debris or oil.
Specific components such as crankshaft oil seals or valve stem oil seals may require lubrication during assembly.
Components requiring lubrication will be identified in the service procedure.
When applying sealant to a component, apply the amount specified in the service procedure.
Do not allow the sealant to enter into any blind threaded holes, as it may prevent the bolt from clamping properly or cause component damage when tightened.
Tighten bolts to specifications. Do not overtighten.