LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 357 (Engine Cooling System) >> Repair Instructions >> Water Pump Replacement (LCV) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Water Pump, Fasteners And Seal
    GM2811959Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the water pump (2) into position with a NEW water pump seal (1) and hand tighten the bolts.
  2. Tighten (3) bolts to 25 N.m (18 lb ft).
  3. Tighten (4) bolt to 25 N.m (18 lb ft).
    4. Fig 2: Thermostat Bypass Pipe, Fasteners And Gasket
    GM2811954Courtesy of GENERAL MOTORS COMPANY
  4. Install the thermostat bypass pipe (2) to the water pump with a NEW gasket (3) and tighten the fasteners (1) to 10 N.m (89 lb in).
    5. Fig 3: Thermostat Housing Connector And Engine Harness Retainer
    GM2811953Courtesy of GENERAL MOTORS COMPANY
  5. Connect the connector (1) to the water outlet.
  6. Install the engine wiring harness retainer (2) to the water pump.
    7. Fig 4: Radiator Outlet Hose And Water Outlet
    GM2811997Courtesy of GENERAL MOTORS COMPANY
  7. Using the BO-38185 hose clamp pliers, install the radiator outlet hose (1) to the water outlet (2).
  8. Install the drive belt. Refer to Drive Belt Replacement .
  9. Install the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement (LCV) .
  10. Fill the cooling system. Refer to Cooling System Draining and Filling (GE-47716) Cooling System Draining and Filling (Static) .
  11. Start the engine and check for coolant leaks.
scientia non olet · About LEMON Manuals