Conditions for Running the DTC
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- DTC P0030, P0031, P0032, P0036, P0037, P0038, P0050, P0051, P0052, P0053, P0054, P0056, P0057, P0058, P0059, P0060, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P010C, P010D, P0111, P0112, P0113, P0114, P0116, P0117, P0118, P0122, P0123, P0128, P0131, P0132, P0133, P0135, P0137, P0138, P013A, P013B, P013C, P013D, P013E, P013F, P0141, P014A, P014B, P0151, P0152, P0153, P0155, P0157, P0158, P015A, P015B, P015C, P015D, P0161, P0201, P0202, P0203, P0204, P0205, P0206, P0222, P0223, P0261, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P0273, P0274, P0276, P0277, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P1248, P1249, P124A, P124B, P124C, P124D, P16F3, P2096, P2097, P2098, P2099, P2101, P2135, P2147, P2148, P2150, P2151, P2153, P2154, P2156, P2157, P216B, P216C, P216E, P216F, P2270, P2271, P2271, or P2273 is not set.
- Engine speed is between 1, 150-2, 650 RPM to enable the catalyst diagnostic. Once the engine speed is in range, the engine speed must be between 1, 100-2, 750 RPM to keep the test enabled.
- Ethanol estimation is not active.
- Evaporative emission (EVAP) purge is not active.
- Post HO2S heaters are ON for greater than 60 s.
- Mass air flow (MAF) is between 3-16 g/s.
- Battery voltage is greater than 10 V.
- Vehicle speed is between 68-129 km/h (42-80 MPH) to enable the catalyst diagnostic. To keep the test enabled the vehicle speed is between 63-132 km/h (39-82 MPH).
- Catalyst calculated temperature is between 500-880°C (932-1, 616°F).
- Engine is operating in closed loop.
- Engine is operating in Decel Fuel Cut Off.
This diagnostic attempts one test during each valid OFF-idle period once the above conditions have been met. This diagnostic attempts up to 4 tests during each drive cycle.