Conditions for Setting the DTC

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

P0133, P015A or P015B

The engine control module detects that the heated oxygen sensor rich-to-lean or lean-to-rich average response time is greater than a calibrated value.

The DTCs set within 60 s when the above condition is met.

P013A

The engine control module detects that the accumulated mass air flow monitored during rich-to-lean transitions between 450-150 mV is greater than 75 grams.

P013B

The engine control module detects that the accumulated mass air flow monitored during lean-to-rich transitions between 300-600 mV is greater than 75 grams.

P013E

The engine control module detects that the heated oxygen sensor voltage has not decreased below 450 mV within a calibrated value of accumulated air flow.

P013F

The engine control module detects that the heated oxygen sensor voltage has not increased above 300 mV within a calibrated value of accumulated air flow.

P2270

The engine control module does not detect a heated oxygen sensor voltage greater than 825 mV before accumulated mass air flow exceeds a calibrated value.

P2271

The engine control module does not detect an heated oxygen sensor voltage less than 100 mV before accumulated mass air flow exceeds a calibrated value.