Conditions for Setting the DTC

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

P0030 or P0036

The engine control module detects an open in the heater circuits of the HO2S when the heater is commanded OFF for greater than 6 s.

P0031 or P0037

The engine control module detects a short to ground in the heater output low side driver circuit of the heated oxygen sensor when the heater is commanded OFF for greater than 6 s.

P0032 or P0038

The engine control module detects a short to voltage in the heater output low side driver circuit of the heated oxygen sensor when the heater is commanded ON for greater than 6 s.

P0053 or P0054

The ECM detects the HO2S heater is not within a specified resistance range at engine start-up.

P0135 or P0141

The ECM detects that the HO2S heater current is greater than 2.5 A or less than 0.3 A for greater than 10 s.

P103B

The heater supply circuit is not within 2 V of the ignition voltage for greater than 3 s

P103C

The ECM detects the HO2S heater supply voltage is less than 6 V for greater than 3 s.