LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 350 (Rear Drive Axle) >> Repair Instructions >> Rear Differential Clutch Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Clutch Control Module
    GM4294894Courtesy of GENERAL MOTORS COMPANY
  1. Position the clutch control module (1) onto the rear axle.
    2. Fig 2: Clutch Control Module Electrical Connector
    GM4294891Courtesy of GENERAL MOTORS COMPANY
  2. Reconnect the electrical connector (1) to the clutch control module.
    3. Fig 3: Clutch Control Module Bracket Bolts
    GM4294890Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    NOTE:

    Apply loctite before installing bolts.

  3. Install the clutch control module bracket bolts (1). Tighten to 6 N.m (53 lb in).
  4. Install the rear drive axle assembly. Refer to Differential Carrier Assembly Replacement 
  5. Remove the support and lower the vehicle.
  6. Reprogram the clutch control module. Refer to Control Module References
scientia non olet · About LEMON Manuals