LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 350 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Axle Shaft Seal And Special Tool
    GM3973500Courtesy of GENERAL MOTORS COMPANY
  1. Position the rear axle seal (1) in the rear differential carrier.
  2. Using a suitable seal driver, install the rear axle seal (1).
  3. Install the rear axle shaft. Refer to Rear Wheel Drive Shaft Replacement - Left Side , Rear Wheel Drive Shaft Replacement - Right Side
  4. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals