LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 350 (Rear Drive Axle) >> Repair Instructions >> Differential Carrier Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Differential Carrier Assembly
    GM4291623Courtesy of GENERAL MOTORS COMPANY
  1. Position the rear differential (1) in the vehicle.
    2. Fig 2: Rear Differential Drive Mounting Bolts
    GM4291620Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the rear differential mounting bolts (1).

    Tighten 

    Tighten the bolt to 160 N.m (118 lb ft).

    3. Fig 3: Front Torque Tube Mounting Bracket Bolt
    GM4291618Courtesy of GENERAL MOTORS COMPANY
  3. Install the torque tube bolt (1).

    Tighten 

    Tighten the bolt to 160 N.m (118 lb ft).

    4. Fig 4: Electronic Clutch Control Module Electrical Connector
    GM4291616Courtesy of GENERAL MOTORS COMPANY
  4. Reconnect the electrical connector (1) for the electronic clutch control module.
  5. Install the propeller shaft assembly. Refer to Two-Piece Propeller Shaft Replacement
  6. Refill the rear differential assembly. Refer to Rear Axle Lubricant Replacement 
  7. Install the rear wheel drive shaft. Refer to Rear Wheel Drive Shaft Replacement - Left Side , Rear Wheel Drive Shaft Replacement - Right Side
  8. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals