LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 350 (Rear Drive Axle) >> Diagnostic Information and Procedures >> Noisy on Turns

Noisy on Turns

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
Cause Correction
Inspect for the proper gear oil levels prior to performing system diagnosis. Refer to Rear Axle Lubricant Replacement .
Operate the vehicle turning in tight circles in both left and right directions. A moan, groan, chatter, or a pulsing type concern may indicate a pump, valve, or clutch pack malfunction within the differential assembly.
Worn or loose rear differential mounts Repair or replace as required.
Loose torque tube bracket or a damaged bracket bushing Tighten the bracket bolts or replace the bracket as required.
Worn axle shaft constant velocity joints Replace the constant velocity joints as required.
Worn wheel bearings Replace the wheel bearings as required.
Incorrect type fluid
Installation of the incorrect type gear oil may create a "moan" type noise within 7,770-25,900 km (3-10,000 miles). Fluid that is "black" in color is to be considered normal and is darkened by the carbon material in the clutch plates.
Replace the rear differential assembly as required.
Fluid replacement will not correct a "moan" condition caused by the use of incorrect oil. Refer to Differential Carrier Assembly Replacement .
Worn clutch pack friction discs Replace the differential assembly.