Diagnostic Aids

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

The clutch service calibration will be the alphanumeric characters of the supplier assigned unique serial number found etched/stamped on the clutch pack housing. The characters must be entered exactly how it appears etched/stamped on the clutch pack housing. The calibration procedure is done through SPS programming and setup.

NOTE:

When entering the alphanumeric characters into the scan tool, be sure to enter the characters as seen.

For the single clutch system (RPO F46), there is only one clutch calibration alphanumeric code.
For the twin clutch system (RPO G99), there are two clutch calibration alphanumeric code. Both codes must be entered during the calibration procedure for the right and left clutch respectively.