Removal Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
WARNING:
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the tire and wheel assembly. Tire and Wheel Removal and Installation
- Disconnect Brake Pipe Fitting (1)
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
- Remove Brake Hose Bracket Nut (1)
- Remove Brake Hose Fitting Bolt (1)
- Remove Brake Hose Fitting Gasket (1) @ Brake Hose Fitting (2) and DISCARD
- Plug the brake caliper inlet to prevent brake fluid loss and contamination.
- Remove Rear Brake Hose
NOTE:
Do NOT reuse the brake hose fitting gaskets.