Circuit/System Verification

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Ignition ON/Vehicle in Service Mode.
Verify that DTCs P0556, P0557, or P0558 are not set.
- If the DTC is set
  Refer to DTC P0556, P0557, or P0558 .
- If the DTC is not set
Verify that the brake booster vacuum system has no damage, leakage or incorrect installation.
- If damage, leakage or incorrect installation is found
  Refer to Brake Assist System Diagnosis .
- If the inspection is OK
Test or replace the B19B Brake Booster Vacuum Sensor.
Verify the DTC does not set while operating the vehicle under the Conditions for Running the DTC.
- If the DTC sets
  Replace the K17 Electronic Brake Control Module.
- If the DTC does not set
All OK.