Liftgate Power Assist Actuator Replacement

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Liftgate Power Assist Actuator

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove Liftgate Lower Trim Finish Panel. Refer to Liftgate Lower Trim Finish Panel Replacement
1	Liftgate Power Assist Actuator WARNING: When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. Procedure Disconnect the pass through grommet. Disconnect the electrical connector. Release the strut retainers/clips. Ensure the retainer/clip is fully seated when rod is reinstalled. If clip cannot be fully seated, a new rod should be installed.

Callout

Component Name

Preliminary Procedure
Remove Liftgate Lower Trim Finish Panel. Refer to Liftgate Lower Trim Finish Panel Replacement

Liftgate Power Assist Actuator

WARNING:

When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Procedure

Disconnect the pass through grommet.
Disconnect the electrical connector.
Release the strut retainers/clips.
Ensure the retainer/clip is fully seated when rod is reinstalled. If clip cannot be fully seated, a new rod should be installed.