Removal Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Door Outside Handle Bracket And Front Side Door Latch

Courtesy of GENERAL MOTORS COMPANY

NOTE:

When performing this procedure the latch and handle bracket assembly Must be removed from the vehicle to replace the door lock cylinder assembly.

Remove Front Side Door Latch (2). Refer to Front Side Door Latch Replacement

Fig 2: Front Side Door Lock Cylinder Rod

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Its not necessary to disconnect the inside or outside handle cables to replace the door lock cylinder.

Remove Front Side Door Lock Cylinder Rod (1) @ Front Side Door Lock Cylinder

Fig 3: Lock Cylinder Retainers

Courtesy of GENERAL MOTORS COMPANY

From the back side of the outside handle bracket, use a suitable tool, push up and down on the lock cylinder retainers (1) releasing the retainer from the cylinder (2).

Fig 4: Lock Cylinder Retainer, Lock Cylinder And Handle Bracket

Courtesy of GENERAL MOTORS COMPANY

With the lock cylinder retainer (1) removed, pull the lock cylinder (2) rearward releasing it from the handle bracket (3).