Circuit/System Verification
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition On/Vehicle In Service Mode
- Operate the component: Open the liftgate.
Verify the scan tool parameter:
- Body Control Module: Rear Closure Ajar Switch = Active
- Liftgate Control Module: Liftgate Latch Pawl Switch = Open
- Liftgate Control Module: Liftgate Latch Ratchet Switch = Open
- If not the specified state
Refer to: Circuit/System Testing
- If the specified state
- All OK.