Circuit/System Verification

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Ignition On/Vehicle In Service Mode
Verify the scan tool parameter: Exterior Driver Door Handle Switch = Inactive
- If not the specified state
  Refer to: Circuit/System Testing
- If the specified state
Verify the scan tool parameter: Exterior Passenger Door Handle Switch = Inactive
- If not the specified state
  Refer to: Circuit/System Testing
- If the specified state
Verify the scan tool parameter: Exterior Left Rear Door Handle Switch = Inactive
- If not the specified state
  Refer to: Circuit/System Testing
- If the specified state
Verify the scan tool parameter: Exterior Right Rear Door Handle Switch = Inactive
- If not the specified state
  Refer to: Circuit/System Testing
- If the specified state
Operate the component: A24D Door Handle Assembly - Driver Exterior Pressed
Verify the scan tool parameter: Exterior Driver Door Handle Switch = Active
- If not the specified state
  Refer to: Circuit/System Testing
- If the specified state
Operate the component: A24P Door Handle Assembly - Passenger Exterior Pressed
Verify the scan tool parameter: Exterior Passenger Door Handle Switch = Active
- If not the specified state
  Refer to: Circuit/System Testing
- If the specified state
Operate the component: A24LR Door Handle Assembly - Left Rear Exterior Pressed
Verify the scan tool parameter: Exterior Left Rear Door Handle Switch = Active
- If not the specified state
  Refer to: Circuit/System Testing
- If the specified state
Operate the component: A24RR Door Handle Assembly - Right Rear Exterior Pressed
Verify the scan tool parameter: Exterior Right Rear Door Handle Switch = Active
- If not the specified state
  Refer to: Circuit/System Testing
- If the specified state
All OK.