LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 333 (Power Door Lock System And Release Systems) >> Diagnostic Information and Procedures >> Door Ajar Indicator Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle Off
  2. Disconnect the appropriate electrical connector: A23 Door Latch Assembly
  3. Test for infinite resistance between the test points:
    • A23D Door Latch Assembly - Driver: Signal terminal 1 & Ground terminal 3 - The switch is in the open position.
    • A23P Door Latch Assembly - Passenger: Signal terminal 5 & Ground terminal 3 - The switch is in the open position.
    • A23LR Door Latch Assembly - Left Rear: Signal terminal 1 & Ground terminal 3 - The switch is in the open position.
    • A23RR Door Latch Assembly - Right Rear: Signal terminal 5 & Ground terminal 3 - The switch is in the open position.
    • If less than infinite resistance 

      Replace the component: A23 Door Latch Assembly

    • If infinite resistance 
  4. Test for less than 3 Ω between the test points:
    • A23D Door Latch Assembly - Driver: Signal terminal 1 & Ground terminal 3 - The switch is in the closed position.
    • A23P Door Latch Assembly - Passenger: Signal terminal 5 & Ground terminal 3 - The switch is in the closed position.
    • A23LR Door Latch Assembly - Left Rear: Signal terminal 1 & Ground terminal 3 - The switch is in the closed position.
    • A23RR Door Latch Assembly - Right Rear: Signal terminal 5 & Ground terminal 3 - The switch is in the closed position.
    • If 3 Ω or greater 

      Replace the component: A23 Door Latch Assembly

    • If less than 3 Ω 
  5. All OK.
scientia non olet · About LEMON Manuals