Circuit/System Verification

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Ignition On/Vehicle In Service Mode
Operate the component: Driver Door Open
Verify the scan tool parameter: Body Control Module Driver Door Ajar Switch = Active
- If not the specified state
  Refer to: Door Ajar Indicator Malfunction
- If the specified state
Verify the scan tool parameter: Keyless Entry Control Module Driver Door Ajar Switch = Active
- If not the specified state
  Refer to: Circuit/System Testing
- If the specified state
Operate the component: Driver Door Closed
Verify the scan tool parameter: Body Control Module Driver Door Ajar Switch = Inactive
- If not the specified state
  Refer to: Door Ajar Indicator Malfunction
- If the specified state
Verify the scan tool parameter: Keyless Entry Control Module Driver Door Ajar Switch = Inactive
- If not the specified state
  Refer to: Circuit/System Testing
- If the specified state
All OK.