Liftgate Description and Operation: Operation

The power liftgate can be commanded to power open and power close by the following methods:

• An open or close command from the interior liftgate rotary switch
• An open command from the liftgate handle switch
• A close command from the liftgate close switch
• An open or close request by a signal from the keyless entry transmitter to the remote control door lock receiver
• The kicking motion of a foot and lower leg under the rear fascia - Sensor location may vary depending upon make and model, refer to owner's manual for the location of the sensors

The liftgate control module will respond to a request by commanding the liftgate latch to release the liftgate and activate the liftgate motor in the liftgate power assist actuator and raise the liftgate to the open position or to lower and cinch the liftgate closed.