LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 327 (Instrument Panel System Displays And Gauges) >> Diagnostic Information and Procedures >> DTC B124F: Universal Serial Bus (USB) Programming >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition » On / Vehicle » In Service Mode
  2. Verify DTC B124F is not set.
    • If the DTC is set 
    1. Perform all necessary programming and setup procedures for the control module:P16 Instrument Cluster
    2. Verify the DTC does not set.
      • If the DTC sets » Replace the component:P16 Instrument Cluster
      • If the DTC is not set
    3. All OK.
    • If the DTC is not set 
  3. All OK.
scientia non olet · About LEMON Manuals