Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Slide the temperature valve actuator (1) back between the mode control cam cover and the air conditioning evaporator and blower module assembly.
- Install Temperature Valve Actuator Bolt (1) and tighten 1.3 N.m (12 lb in)
- Install Brake and Accelerator Pedal Assembly Brake and Accelerator Pedal Assembly Replacement
- Install Floor Front Air Outlet Duct - Left Side (2)Floor Front Air Outlet Duct Replacement - Left Side
- Clear the DTCs from the heater and air conditioning remote control module.
- Perform the actuator calibration procedure. Actuator Recalibration
CAUTION:
Refer to Fastener Caution .