Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connector.
- Install Mode Valve Actuator (2)
- Install Mode Valve Actuator Bolt (1) and tighten 1.3 N.m (12 lb in)
- Install Instrument Panel Outer Air Outlet Duct - Left Side (1) Instrument Panel Outer Air Outlet Duct Replacement - Left Side
- Install Side Window Defogger Outlet Duct - Left Side (2) Side Window Defogger Outlet Duct Replacement - Left Side
- Install Instrument Panel Carrier Instrument Panel Assembly Replacement (IO5/IO6)Instrument Panel Assembly Replacement (IOB)
- Clear the DTCs from the heater and air conditioning remote control module.
- Perform the actuator calibration procedure. Actuator Recalibration
CAUTION:
Refer to Fastener Caution .