LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 321 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Replacement (LGX) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection (Without KL9) Battery Negative Cable Disconnection and Connection (With KL9) 
  2. Remove Warm Up Three-Way Catalytic Converter - Bank 2 Warm Up Three-Way Catalytic Converter Replacement (Bank 1, LGX)Warm Up Three-Way Catalytic Converter Replacement (Bank 2, LGX)
    3. Fig 1: Knock Sensor
    GM4287567Courtesy of GENERAL MOTORS COMPANY
  3. Remove Knock Sensor- Bank 2 (1)Knock Sensor Replacement - Bank 2
    4. Fig 2: Starter Heat Shield
    GM4286549Courtesy of GENERAL MOTORS COMPANY
  4. Remove Starter Heat Shield (2)Starter Shield Replacement (LGX) 
    5. Fig 3: Starter Solenoid Cable Nut And Battery Positive Cable Conduit Fastener
    GM4286416Courtesy of GENERAL MOTORS COMPANY
  5. Remove Starter Solenoid Cable Nut (1)
  6. Remove Battery Positive Cable Conduit Fastener (3)
  7. Remove Battery Positive Cable (2)
    8. Fig 4: Starter Mounting Bolt
    GM4287534Courtesy of GENERAL MOTORS COMPANY
  8. Remove Starter Mounting Bolt (1)
    9. Fig 5: Electrical Connector And Starter
    GM4287535Courtesy of GENERAL MOTORS COMPANY
  9. Disconnect Electrical Connector (1)
  10. Remove the starter.(2)
scientia non olet · About LEMON Manuals