Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electrical Connector And Starter

Courtesy of GENERAL MOTORS COMPANY

Connect Electrical Connector (1)
Install Starter (2)

Fig 2: Starter Mounting Bolt

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution

Install Starter Mounting Bolt (1) and tighten 22 N.m (16 lb ft)

Fig 3: Battery Positive Cable And Nut

Courtesy of GENERAL MOTORS COMPANY

Install Battery Positive Cable (1)
Install Battery Positive Cable Nut (2) and tighten 12.5 N.m (111 lb in)

Fig 4: Wheel Drive Shaft

Courtesy of GENERAL MOTORS COMPANY

Front Wheel Drive Shaft (1)Front Wheel Drive Shaft Replacement - Right Side (FWD)
Lower the vehicle.
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (Without KL9) Battery Negative Cable Disconnection and Connection (With KL9)