Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electrical Connector And Starter

Courtesy of GENERAL MOTORS COMPANY

Connect Electrical Connector (1)
Install Starter (2)

Fig 2: Starter Mounting Bolt

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution

Install Starter Mounting Bolt (1)and tighten 22 N.m (16 lb ft)

Fig 3: Battery Positive Cable And Nut

Courtesy of GENERAL MOTORS COMPANY

Install Battery Positive Cable (1)
Install Battery Positive Cable Nut (2) and tighten 12.5 N.m (111 lb in)

Fig 4: Transfer Case Assembly

Courtesy of GENERAL MOTORS COMPANY

Install Transfer Case Assembly (2) Power Transfer Unit Case Replacement
Lower the vehicle.
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (Without KL9) Battery Negative Cable Disconnection and Connection (With KL9)