Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Install Battery Sensor Module (3)
- Battery Negative Post Clamp Nut (1) Tighten 4.5 N.m (40 lb in)
- Connect Electrical Connector (2)
- Install Battery Negative Cable (3)
- Use an open ended wrench to hold the battery sensor ground tab, while tightening the battery negative cable nut.(2)
- Battery Negative Cable Nut (1) Tighten 12 N.m (106 lb in)
CAUTION:
Refer to Fastener Caution