Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Battery Hold Down Bolt And Battery

Courtesy of GENERAL MOTORS COMPANY

Install Battery
Install Battery Hold Down Retainer

CAUTION:

Refer to Fastener Caution

Install Battery Hold Down Bolt and tighten 22 N.m (16 lb ft)
Install the engine control module bracket along with the engine control module to the battery tray. Engine Control Module Bracket Replacement

Fig 2: Battery Hold Down Retainer Nut

Courtesy of GENERAL MOTORS COMPANY

Install Battery Hold Down Retainer
Install Battery Hold Down Retainer Bolt and tighten 9 N.m (80 lb in)
Install Battery Hold Down Retainer Nut and tighten 9 N.m (80 lb in)

Fig 3: Battery Positive Post Clamp Nut And Battery Distribution Fuse Block Retaining Tab

Courtesy of GENERAL MOTORS COMPANY

Engage Battery Distribution Fuse Block Retaining Tab
Battery Positive Post Clamp Nut Tighten 4.5 N.m (40 lb in)

Fig 4: Battery Distribution Fuse Block Retaining Tab

Courtesy of GENERAL MOTORS COMPANY

Close the battery fuse block cover.
Engage Battery Distribution Fuse Block Retaining Tab
Connect the negative battery cable. Battery Negative Cable Disconnection and Connection (Without KL9) Battery Negative Cable Disconnection and Connection (With KL9)