Removal Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection (Without KL9) Battery Negative Cable Disconnection and Connection (With KL9)
- Remove Battery Distribution Engine Compartment Fuse Block Cover (2)
- Remove Battery Positive Cable Nut (1)
- Remove Battery Positive Cable Nut (3)
- Remove Battery Positive Cable (5)
- Disengage Battery Positive Cable Retainer (4)
- Disengage Battery Positive Cable Retainer (4)
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove Starter Solenoid Cable Nut (2)
- Remove Battery Positive Cable (1)
- Remove Protective Cap (1)
- Remove Generator Nut (2)
- Remove Battery Positive Cable (3)
- Disengage Engine Harness Retainers (3)
- Remove Battery Negative Cable Ground Stud (2)
- Remove Battery Negative Cable (1)
- Disconnect Electrical Connector (1) @Power Steering Assist Motor (2)
- Disengage Retainer (4)
- Remove the battery positive cable from the vehicle.(3)