LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 317 (Supplemental Restraint System) >> Repair Instructions >> Front Seat Inboard Seat Back Airbag Replacement

Front Seat Inboard Seat Back Airbag Replacement

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Seat Inboard Seat Back Airbag and Nuts
GM4353298Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING:

Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

  • The seat cushion frame
  • The seat recliner, if equipped
  • The seat adjuster
  • The seat back frame

Failure to do so may cause future personal injury.

Preliminary Procedures

  1. Disable the SIR system. SIR Disabling and Enabling 
  2. Driver or Passenger Seat Back Cover and Pad Replacement
1 Front Seat Inboard Seat Back Airbag Nut (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
4.7 N.m (42 lb in)
2 Front Seat Inboard Seat Back Airbag

Procedure

  1. Remove the connector position assurance (CPA) from the module electrical connector.
  2. Disconnect the electrical connector.
  3. Enable the SIR System. SIR Disabling and Enabling 
  4. Inflatable Restraint Module Handling and Scrapping 
scientia non olet · About LEMON Manuals