Rollover Protection Disable Switch (If Equipped)

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

If the vehicle has a Rollover Disable switch that you can use to manually turn on or off the deployment of associated airbags and pretensioners when the algorithm has determined that a rollover event is likely and/or imminent. This only prevents the deployment of calibrated airbags and pretensioners in the case of a rollover event; This does not affect deployments due to front, side or rear events.

Upon powering up the vehicle, the rollover enabled airbags and pretensioners are enabled. If it is desired to disable deployments due to a rollover event, the ignition switch must be in the RUN power mode without the engine running. The Rollover Disabled Switch must be pressed and held for several seconds until a confirmation "beep" is heard. The change of state is confirmed as well by the illumination of the Rollover Disable Icon. The engine can then be started. Do not cycle ignition back to OFF before starting the engine, for this will re-enable these airbags.. The rollover disable feature will remain enabled until the ignition is turned off or the rollover disable switch is pressed again to re-enable the associated airbags and pretensioners.