Component Testing

M40 Rear Compartment Lid Latch-Dynamic Test

1. Ignition/Vehicle Off.
2. Disconnect the electrical connector:M40 Rear Compartment Lid Latch
3. Connect a jumper wire between the test points:Ground terminal 2 & Ground
4. Momentarily connect a 10 A fused jumper wire between the test points:Control terminal 1 & 12 V

   Verify the component turns On and Off when connecting and disconnecting the jumper wire: M40 Rear Compartment Lid Latch

   • If the component does not turn On and Off  

     Replace the component:M40 Rear Compartment Lid Latch

   • If the component turns On and Off 
5. All OK.

S58A Rear Compartment Lid Unlatch Switch - Exterior-Test

1. Ignition/Vehicle Off.
2. Disconnect the electrical connector: S58A Rear Compartment Lid Unlatch Switch - Exterior
3. Test for infinite resistance between the test points: Signal terminal 1 & Ground terminal 2-Switch Not Pressed
   • If less than infinite resistance 

     Replace the component: S58A Rear Compartment Lid Unlatch Switch - Exterior

   • If infinite resistance 
4. Test for less than 3 ohm; between the test points: Signal terminal 1& Ground terminal 2-Switch Pressed
   • If 3 or greater  

     Replace the component: S58A Rear Compartment Lid Unlatch Switch - Exterior

   • If less than 3 ohm; 
5. All OK.

S58B Rear Compartment Lid Unlatch Switch - Interior-Test

1. Ignition/Vehicle Off.
2. Disconnect the electrical connector: S58B Rear Compartment Lid Unlatch Switch - Interior
3. Test for infinite resistance between the test points: Signal terminal 1 & Ground terminal 2-Switch Not Pressed
   • If less than infinite resistance 

     Replace the component: S58B Rear Compartment Lid Unlatch Switch - Interior

   • If infinite resistance 
4. Test for less than 3 ohm; between the test points: Signal terminal 1 & Ground terminal 2-Switch Pressed
   • If 3 ohm; or greater  

     Replace the component: S58B Rear Compartment Lid Unlatch Switch - Interior

   • If less than 3 ohm; 
5. All OK.