Component Testing
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the appropriate A23 Door Latch Assembly.
- Test for infinite resistance between the terminals listed below with the switch in the open position.
- A23D Door Latch Assembly-Driver signal terminal 1 and ground terminal 3
- A23P Door Latch Assembly-Passenger signal terminal 5 and ground terminal 3
- If less than infinite resistance
Replace the A23 Door Latch Assembly.
- If infinite resistance
- Test for less than 5 Ω between the terminals listed below with the switch in the closed position.
- A23D Door Latch Assembly-Driver signal terminal 1 and ground terminal 3
- A23P Door Latch Assembly-Passenger signal terminal 5 and ground terminal 3
- If 5 Ω or greater
Replace the A23 Door Latch Assembly.
- If less than 5 Ω
- All OK