Installation Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Position the hydraulic clutch hose/pipe in the vehicle.
Install the lower slave cylinder hose in the vehicle, if replacement was necessary.

Fig 1: Hydraulic Clutch Hose/Pipe, Clutch Slave Cylinder Hose & Retaining Clip

Courtesy of GENERAL MOTORS COMPANY

Connect the hydraulic clutch hose/pipe (1) to the lower slave cylinder hose (2).
Install the retaining clip (3) to the hydraulic clutch hose/pipe (1).

Fig 2: Hydraulic Clutch Hose/Pipe Retainer

Courtesy of GENERAL MOTORS COMPANY

Seat the grommet (3) into the floor panel.
Connect the hydraulic clutch hose/pipe (2) retaining clip to the cowl.

Fig 3: Clutch Pipe & Retaining Clip

Courtesy of GENERAL MOTORS COMPANY

Connect the hydraulic clutch hose/pipe (2) to the clutch master cylinder.
Install the hydraulic clutch hose/pipe retaining clip (1) to the clutch master cylinder.
Raise the vehicle.

Fig 4: Lower Slave Cylinder Hose

Courtesy of GENERAL MOTORS COMPANY

Connect the lower slave cylinder hose (2) to the slave cylinder.
Install the hydraulic clutch hose/pipe retaining clip (1) to the clutch slave cylinder.
Bleed the clutch hydraulic system. Refer to Hydraulic Clutch System Bleeding .
Lower the vehicle.
Install the heater and air conditioning evaporator and blower module in the vehicle. Refer to Heater and Air Conditioning Evaporator and Blower Module Removal and Installation .