Removal Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Pilot Bearing

Courtesy of GENERAL MOTORS COMPANY

Remove the transmission. Transmission Replacement (M3L)Transmission Replacement (MG9)
Remove the clutch assembly. Clutch Assembly Replacement (M3L Transmission)

NOTE:

When using the DT-43276 , always secure the DT-43276-1 tool body using a wrench. Do not allow the DT-43276-1 tool to rotate. Failing to do so causes damage to the DT-43276-1 tool body.

Remove the clutch bearing using the DT-43276 .
1. Install the DT-43276-1 into the clutch pilot bearing.
2. Using a wrench, secure the DT-43276-1 .
3. Insert the DT-43276-2 into the DT-43276-1 .
4. Rotate the DT-43276-2 clockwise into the DT-43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
5. Rotate the DT-43276-2 counterclockwise to remove the DT-43276-2 from the DT-43276-1 .
6. Remove the DT-43276-1 from the tool body.