Circuit/System Verification
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON.
- Verify the parameters listed below do not display Malfunction when commanding the Turbocharger Wastegate Solenoid Valve between 15-95 % with a scan tool.
- Turbocharger Wastegate Solenoid Valve Control Circuit High Voltage Test Status Bank 1
- Turbocharger Wastegate Solenoid Valve Control Circuit Open Test Status Bank 1
- Turbocharger Wastegate Solenoid Valve Control Circuit Low Voltage Test Status Bank 1
- Turbocharger Wastegate Solenoid Valve Control Circuit High Voltage Test Status Bank 2
- Turbocharger Wastegate Solenoid Valve Control Circuit Open Test Status Bank 2
- Turbocharger Wastegate Solenoid Valve Control Circuit Low Voltage Test Status Bank 2
- If Malfunction is displayed
Refer to Circuit/System Testing.
- If Malfunction is not displayed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify a DTC does not set.
- If a DTC sets
Refer to Circuit/System Testing
- If a DTC does not set
- If a DTC sets
- All OK