Removal Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Lifting and Jacking the Vehicle (ATS)Lifting and Jacking the Vehicle (ATS-V)
- Remove the tire and wheel assembly. Tire and Wheel Removal and Installation (Non V-Series)Tire and Wheel Removal and Installation (V-Series)
- Use the tire changer in order to remove the tire from the wheel.
- Remove the TORX screw (1) from the tire pressure sensor (2) and pull it straight off the valve stem (3).
- Remove the tire valve stem by pulling it through the rim.
CAUTION:
Do not scratch or damage the clear coating on aluminum wheels with the tire changing equipment. Scratching the clear coating could cause the aluminum wheel to corrode and the clear coating to peel from the wheel.
NOTE:
When servicing the tire pressure sensor always use a NEW valve stem and NEW TORX screw during installation.